The robot is designed to clean your pool autonomously, without requiring continuous control.

🧠 Autonomous operation

• The robot does not require manual control during cleaning
• Once started, it follows predefined cleaning patterns
• It adapts its behavior automatically based on conditions

👉 No interaction is needed during the cleaning cycle.

▶️ Before starting

Before placing the robot in the pool, you can:

• Select a cleaning mode (on the robot or in the app)
• Configure settings (app only)

👉 The robot must be configured before entering the water.

🔄 During the cleaning cycle

Once in the water and started:

• The robot cleans automatically
• It typically:
  • starts with walls (if enabled)
  • continues with floor cleaning
• It adjusts behavior depending on battery level

👉 Cleaning is not manually controlled.

🔋 Battery and behavior

• With high battery:
  • the robot performs full cleaning (including walls)
• As battery decreases:
  • it prioritizes floor cleaning
• At low battery:
  • it prepares to finish the cycle

🌊 End of the cycle

At the end of the cycle:

• The robot moves to the waterline
• Waits for a short period
• Then switches off if not removed

👉 This is normal behavior to facilitate retrieval.

📱 Role of the app

The app allows you to:

• Configure cleaning modes
• Start a cycle (before submersion)
• Schedule cleaning
• View status (when available)

👉 The app does not control the robot in real time

⚠️ Important

• The robot cannot receive commands underwater
• It does not maintain constant connectivity
• It works independently once started

✅ In summary:
The robot is an autonomous device. You configure it before use, and it performs the cleaning cycle independently without real-time control.