The sensor probe is a consumable component and should be replaced periodically to maintain accurate measurements.
Under normal conditions, the sensor probe has an expected lifespan of approximately 2 years.
When should I replace the probe?
You may need to replace the probe if:
- The probe has reached the end of its expected lifespan.
- Measurements remain inaccurate after calibration.
- The probe is damaged.
- The Fluidra Pool app recommends replacing the probe.
Before replacing the probe
Before replacing the probe:
- Make sure you have a compatible replacement probe.
- Perform the replacement in a clean and dry environment.
- Keep the device in a vertical position throughout the procedure to prevent water from entering the product.
Important precautions
To avoid damaging the device or the new probe:
- Do not touch the sensing areas of the probe with your fingers.
- Do not remove the grease inside the device.
- Replace the seal supplied with the new probe.
- Do not leave the device open longer than necessary.
How do I replace the probe?
- Remove the device from the pool or pipe installation.
- Dry the device thoroughly.
- Remove the sensor cap.
- Unscrew and remove the probe cover.
- Carefully remove the existing probe.
- Remove and discard the old seal.
- Scan the QR code of the new probe using the Fluidra Pool app when requested.
- Install the new seal supplied with the replacement probe.
- Insert the new probe into the device.
- Reinstall and tighten the probe cover until it is securely locked in place.
- Reinstall the sensor cap.
- Place the device back into operation.
What should I do after replacing the probe?
After replacing the probe:
- Return the device to the pool or installation.
- Allow the sensor time to stabilize.
- Measurements may require several hours before becoming fully accurate.
If measurements remain inaccurate after the stabilization period, perform a calibration or contact your retailer or customer support.