1 - Mount the iQBridge RS

  • Use the installation kit (provided) to mount the iQBridge RS on the wall using the screws (close to the device it will be connected to) or directly the device that it will be connected to using the double sided tape.

2 - Connect the iQBridge RS.

Disconnect the device that will be connected (heat pump, salt water chlorinator, etc.) from the main power supply before connecting the iQBridge RS.
  •  Connect the iQBride RS to the device you want to control by simply pugging it in to the device (see example below).
  • Look for the small dedicated watertight plug, accessible from the electrical connection panel (heat pumps) or hanging below the device (salt water chlorinators). 

Once the iQBridge RS is connected to the device you want to control, re-connect the device (heat pump, salt water chlorinator, etc.) to the main power supply. The power ON indicateur light turns on steady green.

The iQBridge RS is powered from the connected product (heat pump, salt water chlorinator, etc.).
If you have not found the information you are looking for in our Help section, do not hesitate to contact us through the Support chat. In case you have a technical issue with your equipment, please check the equipment manual for more information and/or contact your installer.